Cuttlebug Machine and Embossing Folders of your choice
Alcohol Inks and Alcohol Blending Solution
Sharpie Permanent fine tip black marker
Plastic packaging from Cricut Cartridges or Embossing Folders
Small tip paint brush
Cricut Machine and your choice of a frame image
Glossy Accents or Terrifically Tacky Tape
First you are going to begin with a piece of plastic packaging. I used one piece from a Cuttlebug Embossing Folder set (these are larger) and a piece from a Cricut Cartridge. Trim off the edges.
Sandwich the plastic inside the embossing folder.
Layer it on top of the C Plate and under two B Plates.
Run it through your Cuttlebug machine.
Here is the finished piece.
Now you will need the Sharpie and Alcohol Inks. These are some of the colors I used. The ones in the back are Red Pepper, Denim and Butterscotch.
Take the Sharpie and color in the debossed lines that form the outline of the images. I found that coloring small sections at a times works best. If you try to color over a section that is partially dry you will notice that the marker will try to remove the ink. If you missed a spot that you partially colored, wait until it is thoroughly dry and then go back and touch it up.
Another great tip that I did was to do all of these coloring and painting steps on a paper bag…like the ones you can get at the grocery store. Another great way to recycle!
Next you are going to start coloring in the image using the alcohol inks. Flip the plastic piece over from the side you colored in the outlines. Now you are going to paint in the larger sections of the image that are debossed. The black colored lines will act as walls to hold the ink in place until it drys. I added ink to my brush by tipping the bottle to the brush and then gently squeezed the bottle to add a drop or 2 of ink to the tip of the brush. Do this to the side of your project to avoid any unwanted drips.
Then simply color in the sections as you like. I colored all of one color at a time. To get the mottled look, go back and add little touches of ink once your first layer of ink is dry. You can also play with the Blending Solution as well.
Now that your piece is completed, you are ready to add a frame.
I created a frame using the Fancy Frames Cartridge and Cricut Craft Room. I sized the inside of the frame so that it would slightly overlap the edge of my “stained glass” piece and I cut 2 of them. You are going to sandwich your piece between the 2 frames so that it looks finished from both sides. Once they were cut out, I adhered one of them to one side the “stained glass”. I tried 2 different methods. One was using Terrifically Tacky Tape. This was a bit difficult since the tape had to be cut in half length wise because the frame was so thin. This is what is pictured above. The other option is to use Ink Essentials Glossy Accents. This was a bit easier with the thin edges on this particular frame. Before you adhere the second frame, cut an 8 inch length of ribbon or cording to use to hang your piece and attach it to the corners of the frame using the Glossy Accents. The cording/ribbon is also sandwiched between the 2 frames. Now you can attach the second to the backside of your piece.
Your faux stained glass piece is now completed and ready to hang in a window and enjoy!
Here is a close up view of the other piece I created.
I hope you enjoyed this tutorial and project as much as I enjoyed creating them to share with you!